高级搜索

喷嘴总面积与喷吹管截面积比对滤袋清灰性能的影响

,  , 

downloadPDF

上一篇

下一篇

毕远霞, 张留祥, 钱云楼. 喷嘴总面积与喷吹管截面积比对滤袋清灰性能的影响[J]. 环境工程学报, 2017, 11(7): 4210-4216. doi: 10.12030/j.cjee.201605211
引用本文: 毕远霞, 张留祥, 钱云楼. 喷嘴总面积与喷吹管截面积比对滤袋清灰性能的影响[J]. 环境工程学报, 2017, 11(7): 4210-4216. doi: 10.12030/j.cjee.201605211
shu
BI Yuanxia, ZHANG Liuxiang, QIAN Yunlou. Influence of ratio of total area of nozzles on blow tube to cross-sectional area of blow tube on bag cleaning performance[J]. Chinese Journal of Environmental Engineering, 2017, 11(7): 4210-4216. doi: 10.12030/j.cjee.201605211
Citation: BI Yuanxia, ZHANG Liuxiang, QIAN Yunlou. Influence of ratio of total area of nozzles on blow tube to cross-sectional area of blow tube on bag cleaning performance[J]. Chinese Journal of Environmental Engineering, 2017, 11(7): 4210-4216. doi: 10.12030/j.cjee.201605211
shu

喷嘴总面积与喷吹管截面积比对滤袋清灰性能的影响

  • 1.

    四川省宜宾学院资源与环境工程学院, 宜宾 644000

  • 2.

    浙江吉天环保科技有限公司, 杭州 310018

  • 3.

    西南科技大学, 固体废物处理与资源化教育部重点实验室, 绵阳 621010

  • 基金项目:

    西南科技大学研究生创新基金重点项目（15ycx031）

  • 中图分类号: X964

Influence of ratio of total area of nozzles on blow tube to cross-sectional area of blow tube on bag cleaning performance

  • 1.

    College of Resources and Environmental Engineering, Yibin University, Yibin 644000, China

  • 2.

    Zhejiang Ji Tian Environmental and Technology Co. Ltd., Hangzhou 310018, China

  • 3.

    Key Laboratory of Solid Waste Treatment and Resource Recycle, Ministry of Education, Southwest University of Science and Technology, Mianyang 621010, China

  • Fund Project:

  • 摘要: 在自建的脉冲喷吹实验装置上，利用MYD-1540A型压电式压力传感器，对尺寸规格φ120×2 000 mm聚酯无纺布覆PTFE膜滤袋在不同孔管截面积比条件下的滤袋侧壁压力进行测试，实验同时测试了使用不同阀时对应同一孔管截面积比滤袋的侧壁压力，并利用MYD-1380C型压电式压力传感器测试不同阀不同开孔面积时喷吹管内压力随时间的变化。对比分析了同一阀在不同孔管截面积比、不同阀同样孔管截面积比时滤袋的清灰强度，并结合喷吹管内压力随时间变化的曲线分析了孔管截面积比对滤袋清灰性能影响的原理。结果显示：随着孔管截面积比的增大，滤袋清灰强度先增大后减小，喷吹管的最佳孔管截面积比为73.8%，当孔管截面积比达到152.5%及以上或小于26.5%时，清灰强度明显降低；阀的性能会直接影响孔管截面积比对清灰效果的影响；孔管截面积比对滤袋清灰性能影响的本质原因是引起喷吹孔出口气流速度的变化，从而影响压缩空气二次诱导气流量，进而影响滤袋清灰性能。
    Abstract: Piezoelectric transducers (Model MYD-1540A) were utilized to measure the pulse pressure inside bags of different ratios of size (120×2 000 mm). The filter bag was made of non-woven polyester with a PTFE membrane, and was used on experimental pulse-jet equipment. The pulse pressure when different valves were employed corresponding to the same ratio, was also measured. The piezoelectric transducers (Model MYD-1380C) were also utilized to measure the variation of blow-tube air pressures over time, with different valves and different ratios. The cleaning intensities under the following conditions (same valve with different ratios, same ratio with different valves, and different ratios with different number of nozzles) were compared. The principle of the effect of ratio on bag cleaning performance was analyzed in combination with variation of the pressure curve over time in the blow tube. The results showed that the bag cleaning intensity first increases;then decreases as the ratio increases. There is an optimum ratio for the blow tube nozzle settings. The optimum ratio in this study was 73.8%. When the ratio was ≥ 152.5% or ≤ 26.5%, the cleaning intensity clearly dropped. The performance of a valve will directly affect the influence of ratio on the cleaning effect. The essential reason for the effect of the ratio on the cleaning performance is that it causes a change of the airflow velocity at the nozzle exit, thus affecting the secondary air flow induced by the compressed air, which affects the bag cleaning performance.
  • 加载中
  • [1] 瞿晓燕, 沈恒根. 袋式除尘器脉冲清灰喷管及喷口气流组织分析[C]. 全国暖通空调制冷2008年学术年会论文集, 2008
    [2] HUMPHRIES W, MADDEN J J. Fabric filtration for coal-fired boilers: Dust dislodgement in pulse jet filters.[J]. Filtration and Separation, 1983,20(1): 40-42
    [3] SIEVERT J, LOEFFLER F. Dust cake release from non-woven fabrics.[J]. Filtration and Separation, 1987,24(6): 424-427
    [4] SIEVERT J, LFFLER F. Fabric cleaning in pulse-jet filters[J]. Chemical Engineering and Processing: Process Intensification, 1989, 26(2): 179-183
    [5] 党小庆, 刘美玲, 马广大, 等. 脉冲袋式除尘器喷吹气流的数值模拟[J]. 西安建筑科技大学学报(自然科学版), 2008, 40(3): 403-406
    [6] 杨雪莲, 党小庆, 边靖, 等. 袋式除尘器脉冲喷吹清灰过程的数值计算[J]. 重型机械, 2010(3): 56-59
    [7] 李志华, 夏鹏, 刘建凤, 等. 袋式除尘器喷吹过程的数值模拟[J]. 起重运输机械, 2011(10): 26-29
    [8] DENNIS R, KLEMM H A. Modeling concepts for pulse jet filtration[J]. Journal of the Air Pollution Control Association, 1980, 30(1): 38-43
    [9] LU H C, TSAI C J. Numerical and experimental study of cleaning process of a pulse-jet fabric filtration system[J]. Environmental Science & Technology, 1996, 30(11): 3243-3249
    [10] MAO N, OTANI Y, YAO Y, et al. Modeling the filtration process with a flat-type fabric filter[J]. Advanced Powder Technology, 2006, 17(3): 237-256
    [11] ITO S. Pulse jet cleaning and internal flow in a large ceramic tube filter[J]. Gas Cleaning at High Temperatures, 1993: 266-279
    [12] ELLENBECKER M J,LEITH D. Dust removal from non-woven fabric-cleaning methods need to be improved[J].Filtration & Separation,1981,18:41-45
    [13] LEITH D, ELLENBECKER M J. Theory for pressure drop in a pulse-jet cleaned fabric filter[J]. Atmospheric Environment, 1980, 14(7): 845-852
    [14] 沈恒根, 唐华, 邓晓飞,等. 袋式除尘器脉冲阀耗气量与清灰效果的关系的探讨[C]//全国袋式除尘技术研讨会, 2009
    [15] LU H C, TSAI C J. A pilot-scale study of the design and operation parameters of a pulse-jet baghouse[J]. Aerosol Science and Technology, 1998, 29(6): 510-524
    [16] 田玮. 脉冲喷吹袋式除尘器清灰的研究[D]. 西安:西安建筑科技大学, 2005
    [17] 杨迪. 脉冲喷吹滤筒除尘器清灰性能研究[D]. 绵阳:西南科技大学, 2008
    [18] SIMON X, CHAZELET S, THOMAS D, et al. Experimental study of pulse-jet cleaning of bag filters supported by rigid rings[J]. Powder Technology, 2007, 172(2): 67-81
    [19] LO L M, HU S C, CHEN D R, et al. Numerical study of pleated fabric cartridges during pulse-jet cleaning[J]. Powder Technology, 2010, 198(1): 75-81
    [20] 靳爽, 刘后启. 脉冲清灰袋收尘器的设计[J]. 水泥技术, 2007(5): 76-82
    [21] 童庆, 何宏涛, 刘滨, 等. 袋除尘器的优化设计研究与应用[J]. 水泥, 2013(5): 42-43
    [22] 王鹏, 杨青真, 未军光. 脉冲袋式除尘器匀流喷吹管设计研究[J]. 科学技术与工程, 2009, 9(8): 2062-2066
    [23] 汤占岐, 姜国平, 李瑞秋. 袋式除尘器喷吹均匀性的数值模拟[J]. 煤矿机械, 2011, 32(10): 97-99 郑兆光, 宋正华. KDM 大型行喷脉冲袋式除尘器喷吹管的设计和改进. 中国水泥, 2008(10): 77-78
  • 加载中
WeChat 点击查看大图
计量
  • 文章访问数:  1473
  • HTML全文浏览数:  1101
  • PDF下载数:  894
  • 施引文献:  0
出版历程
  • 收稿日期:  2016-08-04
  • 刊出日期:  2017-07-06

喷嘴总面积与喷吹管截面积比对滤袋清灰性能的影响

  • 1. 四川省宜宾学院资源与环境工程学院, 宜宾 644000
  • 2. 浙江吉天环保科技有限公司, 杭州 310018
  • 3. 西南科技大学, 固体废物处理与资源化教育部重点实验室, 绵阳 621010
  • 收稿日期:  2016-08-04
基金项目:

西南科技大学研究生创新基金重点项目（15ycx031）

摘要: 在自建的脉冲喷吹实验装置上，利用MYD-1540A型压电式压力传感器，对尺寸规格φ120×2 000 mm聚酯无纺布覆PTFE膜滤袋在不同孔管截面积比条件下的滤袋侧壁压力进行测试，实验同时测试了使用不同阀时对应同一孔管截面积比滤袋的侧壁压力，并利用MYD-1380C型压电式压力传感器测试不同阀不同开孔面积时喷吹管内压力随时间的变化。对比分析了同一阀在不同孔管截面积比、不同阀同样孔管截面积比时滤袋的清灰强度，并结合喷吹管内压力随时间变化的曲线分析了孔管截面积比对滤袋清灰性能影响的原理。结果显示：随着孔管截面积比的增大，滤袋清灰强度先增大后减小，喷吹管的最佳孔管截面积比为73.8%，当孔管截面积比达到152.5%及以上或小于26.5%时，清灰强度明显降低；阀的性能会直接影响孔管截面积比对清灰效果的影响；孔管截面积比对滤袋清灰性能影响的本质原因是引起喷吹孔出口气流速度的变化，从而影响压缩空气二次诱导气流量，进而影响滤袋清灰性能。

English Abstract

    全文HTML

参考文献 (23)

目录

/

返回文章
返回

Copyright © 2019 中国科学院生态环境研究中心