高级搜索

木镁基碳质吸附剂的制备及其性能

,  ,  , 

downloadPDF

上一篇

下一篇

李志萍, 刘千钧, 冯卿明, 孙斌. 木镁基碳质吸附剂的制备及其性能[J]. 环境工程学报, 2014, 8(10): 4345-4348.
引用本文: 李志萍, 刘千钧, 冯卿明, 孙斌. 木镁基碳质吸附剂的制备及其性能[J]. 环境工程学报, 2014, 8(10): 4345-4348.
shu
Li Zhiping, Liu Qianjun, Feng Qingming, Sun Bin. Preparation and performance investigation of magnesium lignosulfonate-based carbonaceous adsorbent[J]. Chinese Journal of Environmental Engineering, 2014, 8(10): 4345-4348.
Citation: Li Zhiping, Liu Qianjun, Feng Qingming, Sun Bin. Preparation and performance investigation of magnesium lignosulfonate-based carbonaceous adsorbent[J]. Chinese Journal of Environmental Engineering, 2014, 8(10): 4345-4348.
shu

木镁基碳质吸附剂的制备及其性能

  • 1.

    广东工业大学环境科学与工程学院, 广州 510006

  • 2.

    佛山市高明区环境保护监测站, 佛山 528500

  • 3.

    佛山市高明区环保局, 佛山 528500

  • 基金项目:

  • 中图分类号: X703

Preparation and performance investigation of magnesium lignosulfonate-based carbonaceous adsorbent

  • 1.

    Faculty of Environmental Science and Engineering, Guangdong University of Technology, Guangzhou 510006, China

  • 2.

    Gaoming District Environmental Protection Monitoring Station, Foshan 528500, China

  • 3.

    Gaoming District Environmental Protection Bureau, Foshan 528500, China

  • Fund Project:

  • 摘要: 用木镁聚合物（PML）制备碳质吸附剂，探讨了影响产物吸附性能的主要制备因素。结果表明，当活化温度为400℃，磷料比为2：1和活化时间为2.5 h时，木镁基碳质吸附剂（MLCA）的吸附性能较好，其亚甲基蓝吸附值为142.5 mg/g，碘吸附值为946.43 mg/g。红外光谱分析表明，经过高温处理后，产物保持了PML的基本结构特征，而其比表面积由0.07 m2/g增大至642.38 m2/g。MLCA对染料亚甲基蓝的吸附过程符合Langmuir吸附等温式。
    Abstract: Magnesium lignosulfonate-based carbonaceous adsorbent (MLCA) was made from polymer of magnesium lignosulfonate(PML).Main factors affecting adsorption capacity of MLCA were investigated.The results indicated that MLCA showed a better adsorption performance,while it was made under 400℃of activation temperature,2:1 of impregnation ratio and 2 h of activation time.The adsorption capacity of it for methylene blue and iodine were 142.5 mg/g and 946.43 mg/g,respectively.The results of infrared spectroscopy showed that,after being treated at high temperature,MLCA retained the basic structure of PML,nevertheless,specific surface area of it increased from 0.07 m2/g to 642.38 m2/g.The adsorption of methylene blue on MLCA was in accordance with the Langmuir adsorption isotherm.
  • 加载中
  • [1] Ravikumar K.,Deebika B.,Balu K.Decolourization of aqueous dye solutions by a novel adsorbent:Application of statistical designs and surface plots for the optimization and regression analysis.Journal of Hazardous Materials,2005,122(1-2):75-83
    [2] Iqbal M.J.,Ashiq M.N.Adsorption of dyes from aqueous solutions on activated charcoal.Journal of Hazardous Materials,2007,139(1):57-66
    [3] Rafatullah M.,Sulaiman O.,Hashim R.,et al.Adsorption of methylene blue on low-cost adsorbents:A review.Journal of Hazardous Materials,2010,177(1-3):70-80
    [4] Métivier-Pignon H.,Faur-Brasquet C.,Cloirec P.L.Adsorption of dyes onto activated carbon cloths:Approach of adsorption mechanisms and coupling of ACC with ultrafiltration to treat coloured wastewaters.Separation and Purification Technology,2003,31(1):3-11
    [5] Xiao B.,Sun X.F.,Sun R.C.The chemical modification of lignins with succinic anhydride in aqueous systems.Polymer Degradation and Stability,2001,71(2):223-231
    [6] Suhas,Carrott P.J.M.,Carrott M.M.L.Lignin-from natural adsorbent to activated carbon:A review.Bioresource Technology,2007,98(12):2301-2312
    [7] Montané D.,Torné-Fernández V.,Fierro V.Activated carbons from lignin:kinetic modeling of the pyrolysis of Kraft lignin activated with phosphoric acid.Chemical Engineering Journal,2005,106(1):1-12
    [8] Zhang Q.L.,Chuang K.T.Adsorption of organic pollutants from effluents of a Kraft pulp mill on activated carbon and polymer resin.Advances in Environmental Research,2001,5(3):251-258
    [9] 唐志红,朱文魁,张双全.磷酸法木质活性炭的研究现状.炭素技术,2004,23(1):45-48 Tang Zhihong,Zhu Wwnkui,Zhang Shuangquan.The present status of wood-based activated carbon by H3PO4 activation.Carbon Techniques,2004,23(1):45-48
    [10] Liou T.H.Development of mesoporous structure and high adsorption capacity of biomass-based activated carbon by phosphoric acid and zinc chloride activation.Chemical Engineering Journal,2010,158(2):129-142
    [11] Castro J.B.,Bonelli P.R.,Cerrella E.G.,et al.Phosphoric acid activation of agricultural residues and bagasse from sugar cane:Influence of the experimental conditions on adsorption characteristics of activated carbons.Industrial & Engineering Chemistry Research,2000,39(11):4166-4172
    [12] Pietrzak R.,Bandosz T.J.Reactive adsorption of NO2 at dry conditions on sewage sludge-derived materials.Environmental Science & Technology,2007,41(21):7516-7522
  • 加载中
WeChat 点击查看大图
计量
  • 文章访问数:  1697
  • HTML全文浏览数:  1134
  • PDF下载数:  1503
  • 施引文献:  0
出版历程
  • 收稿日期:  2014-01-05
  • 刊出日期:  2014-09-28
李志萍, 刘千钧, 冯卿明, 孙斌. 木镁基碳质吸附剂的制备及其性能[J]. 环境工程学报, 2014, 8(10): 4345-4348.
引用本文: 李志萍, 刘千钧, 冯卿明, 孙斌. 木镁基碳质吸附剂的制备及其性能[J]. 环境工程学报, 2014, 8(10): 4345-4348.
shu
Li Zhiping, Liu Qianjun, Feng Qingming, Sun Bin. Preparation and performance investigation of magnesium lignosulfonate-based carbonaceous adsorbent[J]. Chinese Journal of Environmental Engineering, 2014, 8(10): 4345-4348.
Citation: Li Zhiping, Liu Qianjun, Feng Qingming, Sun Bin. Preparation and performance investigation of magnesium lignosulfonate-based carbonaceous adsorbent[J]. Chinese Journal of Environmental Engineering, 2014, 8(10): 4345-4348.
shu

木镁基碳质吸附剂的制备及其性能

  • 1.  广东工业大学环境科学与工程学院, 广州 510006
  • 2.  佛山市高明区环境保护监测站, 佛山 528500
  • 3.  佛山市高明区环保局, 佛山 528500
  • 收稿日期:  2014-01-05
基金项目:

摘要: 用木镁聚合物（PML）制备碳质吸附剂，探讨了影响产物吸附性能的主要制备因素。结果表明，当活化温度为400℃，磷料比为2：1和活化时间为2.5 h时，木镁基碳质吸附剂（MLCA）的吸附性能较好，其亚甲基蓝吸附值为142.5 mg/g，碘吸附值为946.43 mg/g。红外光谱分析表明，经过高温处理后，产物保持了PML的基本结构特征，而其比表面积由0.07 m2/g增大至642.38 m2/g。MLCA对染料亚甲基蓝的吸附过程符合Langmuir吸附等温式。

English Abstract

    全文HTML

参考文献 (12)

返回顶部

目录

/

返回文章
返回

Copyright © 2019 中国科学院生态环境研究中心