熔盐法去除污泥焚烧灰中磷的效果及热动力学分析
Molten salt in removal of phosphorus in incinerated sewage sludge ash with thermodynamics models
-
摘要: 利用碳还原剂和氯化钙熔盐药剂在1100℃下还原污泥焚烧灰中的磷酸盐为气态磷单质并去除,采用X射线衍射分析(XRD)残渣的组成和热重质谱(TGA-MS)分析反应过程.结果表明,添加氯化钙可显著提高污泥焚烧灰除磷效率,氯化钙的最优添加量为25%质量分数,此时污泥焚烧灰除磷效率为82%.XRD结果显示,污泥焚烧灰经熔盐处理后形成了氯磷灰石(chlorapatite),珍珠云母(margarite)等物质,其中氯磷灰石的形成有利于焚烧灰中磷的还原.对TGA-MS结果进行热解动力学反应拟合,结果显示,污泥焚烧灰除磷反应在添加少量氯化钙添加时为均相反应;污泥焚烧灰除磷反应在添加较多氯化钙时为固相扩散反应.固相反应的发生有利于降低磷酸盐还原反应温度并提高去除效率.Abstract: Phosphate in the Incinerated Sewage Sludge Ash (ISSA) was removed by carbon reducing agent and molten salt agent at 1100 ℃. The composition of the residue was analyzed by X-ray diffraction analysis (XRD) and thermogravimetric mass spectrometry (TGA-MS) reaction process. The results showed that the addition of calcium chloride could significantly improve the phosphorus removal efficiency of sludge incineration ash. The optimal amount of calcium chloride was 25% by mass. At this time, the phosphorus removal efficiency of sludge incineration ash was 82%. XRD results showed that chlorapatite, margarite and other substances were formed after ISSA was treated with molten salt. Among them, the formation of chlorapatite was beneficial to the reduction of phosphorus in ISSA. The pyrolysis kinetics reaction fitting of TGA-MS results showed that the phosphorus removal reaction of ISSA was a homogeneous reaction when a small amount of calcium chloride added; and solid phase diffusion reaction occurred when more calcium chloride added. The occurrence of solid phase reaction was beneficial to reduce the temperature of phosphate reduction reaction and improve the removal efficiency.
-
[1] MURAKAMI T, SUZUKI Y, NAGASAWA H, et al. Combustion characteristics of sewage sludge in an incineration plant for energy recovery[J]. Fuel Processing Technology, 2009, 90(6):778-783. [2] KELESSIDIS A, STASINAKIS A S. Comparative study of the methods used for treatment and final disposal of sewage sludge in European countries[J]. Waste Management, 2012, 32(6):1186-1195. [3] 鲁刘磊, 欧阳东, 温喜廉. 活化污泥焚烧灰胶凝活性的试验研究[J]. 硅酸盐通报, 2014, 33(6):1556-1561. LU L L, OU Y D, WEN X L. Experimental study on cementitous reactivity of activated sludge incieration ash[J]. Bulletin of the Chinese Ceramic Society, 2014, 33(6):1556-1561(in Chinese).
[4] 钱觉时, 谢从波, 谢小莉,等. 城市生活污水污泥建材利用现状与研究进展[J]. 建筑材料学报, 2014, 17(5):829-836. QIAN J S, XIE C B, XIE X L, et al. Utilization of municipal sewage sludge as building materials:A state-of-the-art review[J]. Journal of Building Materials, 2014, 17(5):829-836(in Chinese).
[5] DONATELLO S, TYRER M, CHEESEMAN C R. EU landfill waste acceptance criteria and EU hazardous waste directive compliance testing of incinerated sewage sludge ash[J]. Waste Management, 2010, 30(1):63-71. [6] LIN W Y, NG W C, WONG B S E, et al. Evaluation of sewage sludge incineration ash as a potential land reclamation material[J]. Journal of Hazardous Materials, 2018, 357:63-72. [7] LIN Y, ZHOU S, LI F, et al. Utilization of municipal sewage sludge as additives for the production of eco-cement[J]. Journal of Hazardous Materials, 2012, 213/214:457-465. [8] BAEZA F, PAY J, GALAO O, et al. Blending of industrial waste from different sources as partial substitution of portland cement in pastes and mortars[J]. Construction and Building Materials, 2014, 66:645-653. [9] 张宇宁, 朱京海. 城市污泥处置技术及资源化利用研究综述[J]. 环境保护与循环经济, 2019, 39(4):5-7. ZHANG Y N, ZHU J H. Review of sewage sludge desposal technic and recovery[J]. Recycle Economy, 2019, 39(4):5-7(in Chinese).
[10] NAKAKUBO T, YOSHIDA N, HATTORI Y. Analysis of greenhouse gas emission reductions by collaboratively updating equipment in sewage treatment and municipal solid waste incineration plants[J]. Journal of Cleaner Production, 2017, 168:803-813. [11] YUSUF R O, NOOR Z Z, DIN M D F M D, et al. Use of sewage sludge ash (SSA) in the production of cement and concrete-A review[J]. International Journal of Global Environmental Issues, 2012, 12(2/3/4):214-228. [12] STANĚK T, SULOVSK P. The influence of phosphorous pentoxide on the phase composition and formation of Portland clinker[J]. Materials Characterization, 2009, 60(7):749-755. [13] LIANG S, CHEN H, ZENG X, et al. A comparison between sulfuric acid and oxalic acid leaching with subsequent purification and precipitation for phosphorus recovery from sewage sludge incineration ash[J]. Water Research, 2019, 159:242-251. [14] GUEDES P, COUTO N, OTTOSEN L M, et al. Phosphorus recovery from sewage sludge ash through an electrodialytic process[J]. Waste Management, 2014, 34(5):886-892. [15] C RDOVA UDAETA M, DODBIBA G, PONOU J, et al. Recovery of phosphorus from sewage sludge ash (SSA) by heat treatment followed by high gradient magnetic separation and flotation[J]. Advanced Powder Technology, 2017, 28(3):755-762. [16] ARNOUT S, NAGELS E. Modelling thermal phosphorus recovery from sewage sludge ash[J]. Calphad, 2016, 55:26-31. [17] DHIR R K, GHATAORA G S, LYNN C J. 5-concrete-related applications//DHIR R K, GHATAORA G S, LYNN C J. Sustainable construction materials[M]. Sawston, Cambridge,UK, 2017:111-158. [18] DONATELLO S, CHEESEMAN C R. Recycling and recovery routes for incinerated sewage sludge ash (ISSA):A review[J]. Waste Management, 2013, 33(11):2328-2340. [19] 李艳, 戢峻, 李鹏飞,等. 中低品位磷矿碳热还原工艺优化[J]. 化学与生物工程, 2019, 36(9):11-15. LI Y, JI J, LI P F, et al. Optimization in carbothermal reduction process of medium-low grade phosphate ore[J]. Chemistry & Bioengineering, 2019, 36(9):11-15(in Chinese).
[20] GB/T-11893-1989. 水质总磷的测定钼酸铵分光光度法[S]. 北京:中国标准出版社,1989. GB/T-11893-1989. Water quality-Determination of total phosphorus-Ammonium molydbate spectrophotometric method[S]. Beijing:Standards Press of China, 1989(in Chinese). [21] ZHOU Z, DONG P, WANG D, et al. Silicon-titanium nanocomposite synthesized via the direct electrolysis of SiO2/TiO2 precursor in molten salt and their performance as the anode material for lithium ion batteries[J]. Journal of Alloys and Compounds, 2019, 781:362-370. [22] KATASHO Y, YASUDA K, NOHIRA T. Electrochemical reduction behavior of simplified simulants of vitrified radioactive waste in molten CaCl2[J]. Journal of Nuclear Materials, 2018, 503:290-303. [23] PARK H S, KIM I T, CHO Y Z, et al. Stabilization/solidification of radioactive salt waste by using xSiO2-yAl2O3-P2O5 (SAP) Material at Molten Salt State[J]. Environmental Science & Technology, 2008, 42(24):9357-9362. [24] LEE K R, RILEY B J, PARK H S, et al. Investigation of physical and chemical properties for upgraded SAP (SiO2Al2O3P2O5) waste form to immobilize radioactive waste salt[J]. Journal of Nuclear Materials, 2019, 515:382-391. [25] NASIRI-TABRIZI B, FAHAMI A, EBRAHIMI-KAHRIZSANGI R. Phase transitions and structural changes of nanostructured chlorapatite under thermal treatment[J]. Ceramics International, 2014, 40(1):901-910. [26] PENG J, CHEN H, JIN X, et al. Phase-Tunable Fabrication of Consolidated (α+β)-TiZr Alloys for Biomedical Applications through Molten Salt Electrolysis of Solid Oxides[J]. Chemistry of Materials, 2009, 21(21):5187-5195. [27] PANG Z, ZOU X, ZHENG K, et al. Sustainable synthesis of Cr7C3, Cr2AlC, and their derived porous carbons in molten salts[J]. ACS Sustainable Chemistry & Engineering, 2018, 6(12):16607-16615. [28] YIN H, MAO X, TANG D, et al. Capture and electrochemical conversion of CO2 to value-added carbon and oxygen by molten salt electrolysis[J]. Energy & Environmental Science, 2013, 6(5):1538. [29] JIAO S, HU L, YANG S, et al. Electrochemical extraction of carbon nanotubes from CO2 in CaCl2 based melts[J]. Journal of Materials Chemistry A, 2017, 5(13):6219-6225. [30] DENG B, TANG J, GAO M, et al. Electrolytic synthesis of carbon from the captured CO2 in molten LiCl-KCl-CaCO3:Critical roles of electrode potential and temperature for hollow structure and lithium storage performance[J]. Electrochimica Acta, 2018, 259:975-985. [31] 孙国超, 李燕凤, 袁圣娟. 窑法磷酸工业生产评述[J]. 化肥工业, 2019, 46(3):10-15. SUN G C, LI Y F, YUAN S J. Review of Industrial Production of Kiln Process Phosphoric Acid[J]. Journal of Chemical Fertilizer Industry, 2019, 46(3):10-15(in Chinese).
计量
- 文章访问数: 2371
- HTML全文浏览数: 2371
- PDF下载数: 34
- 施引文献: 0