[1] Indrek Kulaots, Alex Hsu, Robert H. Hurt, et al. Adsorption of surfactants on unburned carbon in fly ash and development of a standardized foam index test. Cement and Concrete Research, 2003,33(12):2091-2099
[2] Lu P., Li C., Zeng G., et al. Research on soot of black smoke from ceramic furnace flue gas: Characterization of soot. Journal of Hazardous Materials, 2012,199(1):272-281
[3] 王之顺. 窑炉烟气净化和控制燃烧相结合技术. 城市环境与城市生态,2003,16(1):68-69 Wang Zhishun. Combined technology of smoke removeal and bunring control in kiln. Urban Environment & Urban Ecology, 2003,16(1):68-69(in Chinese)
[4] Ahmadi Goodarz, Smith Duane H. Particle transport and deposition in a hot-gas clean up pilot plant. Aerosol Science and Technology, 2004,29(3):183-205
[5] Enders M., Putnis A., Albrecht J., et al. Temperature-dependent fractionation of particulate matter and sulfates from a hot flue gas in pressurized pulverized coal combustion (PPCC). Energy Fuels, 2000,14(4):806-815
[6] McMahon Theodore J. Advanced hot gas filter development. Ceramic Engineering and Science Proceedings, 2000,21(3):47-56
[7] Thomas J. Overcamp, Sridhar V. Mantha. A simple method for estimating cyclone efficiency. Environmental Progress, 1998,17(2):77-79
[8] Yuet P. K., Blankschtein D., et al. Approximate expressions for the surface potentials of charged vesicles. Langmuir, 1995,11(6):1925-1933
[9] Martin Branis, Marketa Domasova. PM10 and black smoke in a small settlement: Case study from the Czech Republic. Atmospheric Environment, 2003,37(1):83-92
[10] Yoshihiro Takeuchil, Kazuhiro Fujiki, Norio Tsubokawa, et al. Preparation of amphiphilic carbon black by post grafting of polyethyleneimine to grafted polymer chains on the surface. Polymer Bulletin, 1998,41(1):85-90
[11] Gerard Hoek, Hans Welinder, Eva Vaskovi, et al. Interlaboratory comparison of PM10 and black smoke measurements in the peace study. Atmospheric Environment, 1997,31(20):3341-3349
[12] Ridaoui H., Jada A., Vidal L., et al. Effect of cationic surfactant and block copolymer on carbon black particle surface charge and size. Colloids and Surfaces A: Physicochem. Eng. Aspects, 2006,278 (1/3):149-159
[13] 李彩亭,王丽平,曾光明,等. 复合表面活性剂对燃煤陶瓷窑炉黑烟润湿作用的研究. 环境污染治理技术与设备,2005,6(11):23-27 Li Caiting, Wang Liping, Zeng Guangming, et al. Study on the wetting of black smoke from coal-fired ceramic kilns by composite surfactant solutions. Techniques and Equipment for Environmental Pollution Control, 2005,6(11):23-27(in Chinese)
[14] 崔箫,李彩亭,王飞,等. 基于表面活性剂和混凝机理控制陶瓷窑炉黑烟污染的实验研究. 环境科学研究,2006,4(19):80-85 Cui Xiao, Li Caiting, Wang Fei, et al. Experimental study on control of black smoke pollution from the ceramic kilns based on surfactant and coagulation mechanism. Research of Environmental Sciences, 2006,4(19):80-85(in Chinese)
[15] 余娜,孙丹,韩兆让,等. CTAB/SDBS囊泡的自发形成与聚合. 化学学报,2008,66(3):315-320 Yu Na, Sun Dan, Han Zhaorang, et al. Spontaneous formation and polymerization of CTAB/SDBS vesicles. Acta Chimica Sinica, 2008,66(3):315-320(in Chinese)
[16] 王艳玉. 表面活性剂复配系统双水相研究. 杭州:浙江大学硕士学位论文, 2010 Wang Yanyu. Study on the aqueous two-phase systems of surfactant mixtures. Hangzhou:Thesis Master’s Degree Thesis of Zhejiang University, 2010(in Chinese)
[17] Barbara Simoni, Mateja Kert. A study of anionic dye-cationic surfactant interactions in mixtures of cationic and nonionic surfactants. Dyes and Pigments, 2002,54(3):221-237
[18] Singh B. P. The influence of surface phenomena on the dewatering of fine clean coal. Filtration & Separation, 1997,34(2):159-163
[19] 谢旭文,李彩亭,路培,等. 用于湿法净化黑烟表面活性剂筛选的数学模型研究. 环境科学学报,2010,31(10):2541-2546 Xie Xuwen, Li Caiting, Lu Pei, et al. Study on the mathematic model about surfactants screening used for smoke wet purification. Environmental Science, 2010,31(10):2541-2546(in Chinese)
[20] 汤鸿霄. 无机高分子絮凝剂理论与絮凝剂. 北京: 中国建筑工业出版社, 2006
[21] 郭祥峰,贾丽华. 阳离子表面活性剂及应用. 北京: 化学工业出版社, 2002
[22] 苏丁, 雷灵琰, 王建新,等. 凝聚剂、絮凝剂在难净化煤泥水中的使用. 选煤技术, 2000,4(2):10-11 Su Ding, Lei Lingyan, Wang Jianxin, et al. Application of coagulant and flocculant in treatment of diffcult-to-clean coal slurry. Goal Preparation Technology, 2000,4(2):10-11(in Chinese)